Other Pages

Your local Garage Door and remote control specialist
Local Rate Number
t: 0330 660 1022
Menu

Transfering the code from an existing BiSecur transmitter to a new BiSecur transmitter

Transfering the code from an existing BiSecur transmitter to a new BiSecur transmitter

Info Sheet: ABi011 – Transfering the code from an existing BiSecur transmitter to a new BiSecur transmitter
Series 3 Hand Transmitters

Please note: To transfer the code from one hand transmitter to another, the signal strength needs to be very strong. This means the units need to be very close together and have a good battery power.

Transfering the code from a BiSecur hand transmitter to a BiSecur hand transmitter

Transfering the code from a BiSecur hand transmitter to a BiSecur hand transmitter

1. Press and hold the button on your existing hand transmitter (which has the code you want to transfer). The LED will illuminate constantly then start to flash red and blue, keep the button pressed down until the code has been successfully transferred (Please be aware this will activate your device / garage door).

2. Once the first hand transmitter has started to flash red and blue, press and hold the button on the hand transmitter which is to receive the code. The LED will flash blue slowly for a few seconds then flash quickly for a few seconds, and then stop with no illumination. The code has now been transferred. You can continue this process to transfer the code to different buttons.

Video demonstrating procedure

More information

View PDF instructions.

View Reset a BiSecur hand transmitter – Erasing and resetting all the codes to 128bit mode, replacing batteries

View more Hormann how to guides.

Share

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.

Categories